Vinyl Express Qe60, User Manual

Page: 22 / 116

2 – 8
Raising the media set lever displays a menu for selecting the media mode. Select the media mode.
Pressing the or key displays “ROLL1 PRESS ENTR”, “ROLL2 PRESS ENTR”, and “SHEET
PRESS ENTR”. Select “SHEET PRESS ENTR” and then press the (ENTER) key to confirm the
selection. When “SHEET PRESS ENTR” is selected, the front and rear edges are detected.
After the medium size has been detected, the pen carriage returns to the origin point and the cutting plotter
awaits cutting data. If the INTERFACE conditions or COMMAND mode have not yet been set, they should
be set. If they have already been set, adjust the cutter pen. Once the cutter pen has been adjusted, the
cutting plotter is ready to perform cutting, so cutting data can be sent from the application software on the
computer.
■
Aligning the Push Rollers
Adjust the position of the left- and right-hand push rollers to suit the medium width. Position the push roll-
ers at either edge of the medium so that they are above the grit rollers. Adjust the push rollers so that they
are positioned above both the medium and the grit rollers. Positioning the push rollers within the push-
roller alignment marks ensures that they are above the grit rollers.
Step
4
If the “REALIGN ROLLERS” message is displayed when the medium is loaded
and the media set lever is raised, either the right-hand push roller is not positioned
over the right-hand wide grit roller, or the left-hand push rollers are not positioned
over the grit roller. Check to confirm that they are positioned correctly.
Step
5
Step
6
To move the push rollers, the media set lever must be in the lowered position.
S H E E T P R E S S E N T R
CHECKPOINT
Push-roller alignment mark
NG NG
OK OK
CAUTION