Rev. 2.0 - EN EU - fw 5.22
Setup Guide
8
Avoid overheating the unit by ensuring good ventilation. Make sure
that cooling apertures on the top and bottom panels are unobstruct-
ed. Avoid installing the PedalPro directly above or below heat-radiat-
ing devices, such as power amplifiers and tube gear.
The machine should have come to you with the switch already set
for the voltage currently in use in your country. Please check wheth-
er this is the case by inspecting the position of switch 17 on the
back panel. Use only VR supplied power cords. Vintage Revolution
cannot be held responsible in the case of ensuing malfunctioning or
failure.
OUTPUT
LEFT
(mono)
OFF
ON
EXT. EFFECT
SEND
External pedal
(optional)
←
←
EXT. EFFECT
RETURN
IN
PedalPro
TM
(
)
OFF
ON
È 1/4
Pl ay:
0Ç P
s
reP
0
0
h
u
a
C m p
o
Di st Ng e
t
e m
Tr
er
ADES
TM
Pedalino
TM
foot controller
(optional)
n o e xpr . pe
000 Ó Pu r ePhase r
da l
7.1 MOUNTING THE UNIT
In a 19” rack
•
The PedalPro is a standard 2U 19” module. Find a suitable space in your
rack and use the mounting screws provided.
On a flat surface
You can also rest your PedalPro on a flat, dry, solid surface of sufficient size.
Avoid resting your PedalPro on the floor – its mechanical and electrical com-
ponents may not withstand shocks from inadvertently kicking or stepping on it.
7
7.2 CONNECTING TO THE MAIN
•
Use the power cord supplied to connect your PedalPro to the main. Plug
one end of the cord into power connector 15 and the other end into an
earthed main socket.
7.3 CONNECTING YOUR INSTRUMENT
•
Connect your instrument to the
input
jack [
22
] on the rear panel.
If you connect your guitar or another instrument when the PedalPro is
on, first turn your amplifier(s) off, or press the Soft Mute key 9. The yel-
low light on the Soft Mute key 9 indicates that the processor is now
muted. You should also do this when switching instruments.
7.4 CONNECTING AMPS / MIXERS
Mono set-up
The diagram below shows you how to connect the PedalPro to a mono
power amplifier, a mixer using a mono input, or a mono amp/speaker rig.
•
Connect a single mono instrument cable between the
OUTPUT LEFT
(mono)
connector [
20a
] of the PedalPro and the input of your amplifier.
