- 10 -
5) Removing the Thermistor
1. Unplug the cooling unit or disconnect power.
2. Remove the outer cover.
3. Remove all the upper and lower side styrofoam pieces.
4. Remove the fan plate.
5. Disconnect the thermistor from the temperature controller.
6. Remove the thermistor from the mounting clip on the front of the
evaporator.
6) Removing the Fans
Figure 2-9
The 2 condenser and evaporator fans are attached to the horizontal fan plate.
They are the same and all powered up at the same time.
1. Unplug the cooling unit or disconnect power.
2. Remove the outer cover.
4. Remove all the upper and lower styrofoam pieces.
5. Disconnect the two wires at the terminal block.
6. Remove the four screws holding the fan to the plate.
8) Removing the Start Relay and Overload Protector
1. Unplug the WINEMATE cooling unit or disconnect power.
2. Remove the outer cover.
3. Remove all the lower styrofoam pieces.
4. Remove the terminal cover from the compressor.
5. Remove the start relay by pulling straight out away from the compressor
terminal.
Summary of Contents for WINE-MATE VINO3500HZD
Page 2: ...1 SAFETY INFORMATION...
Page 8: ...7 Figure 2 3 Figure 2 4...