Villager VCSB 12 S, Original Instruction Manual

Page: 28 / 149

13
Villager VCSB 12 S (GB)
b) If you need to exit “ENGINE START” mode, press “ENGINE START” once, the light
below “ENGINE START” will turn off, which represents that the charger has
already exited “ENGINE START and turn into charging mode.
Warning!
1.
Do not crank engine for > 5s
2. Wait approximately 180s between starting attempts
3. Do not attempt to start more than three times. If three attempts fail, the
vehicle’s
battery should be recharged 15-30 minutes
Warning!
The charging process must be monitored and the charging time limited. Please
follow the instructions of the battery manufacture.
Continuous connection of the charger can damage the battery.
Pay attention to connect the Positive and negative of battery correctly
.
End charging process
1. Unplug from the AC outlet.
2. Disconnect the charging clamp(black) from the vehicle’s bodu, in exceptions
from the negative battery terminal (marked N or -)
3. Disconnect the positive chargiing clamp(red) from the positive battery terminal
(marked P or +).
Warning!
4.
Before use, carefully read the instruction manual and retain for future
reference.
5. Start charging voltage is 3V, when users’ battery voltage is less 3V , the charger
will not have any function of the output.
6. For engine start, the maximum engine cranking time is 5sec with a minimum off
time of 180sec. Do not attempt Engine Start more than 3 times at one time.
7. The battery charger & engine starter is not weather proof. So care and common
sense must be exercised if using outdoors. Do not expose to moisture.
8. Never smoke near the charging area, it will cause a spark or charge near an
open flame.Please move the conductive materials away, which will short circuit
the charger or battery terminals.