Villager VCSB 12 S, Original Instruction Manual

Page: 22 / 149

7
Villager VCSB 12 S (GB)
to the mains with wet or moist hands.
20. Never carry charger by cord or yank it to disconnect from receptacle.
21. After charging or before attempting any maintenance or cleaning, unplug the
charger from the power source.
22. Always disconnect the charger by pulling out the power plug other than cord
whenever disconnecting charger.
23. Make sure cord is located so that it will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
24. If the cables need to be run through walls with sharp edges, for example metal
sheets, use tubes or cable ducts to prevent damage to the cables. Lay electrical
cables in such a way that it is not possible to stumble over them, thereby
preventing damage.
25. Do not operate or disassemble charger if it has received a sharp blow, been
dropped, or otherwise damaged in any way; take it to a qualified serviceman.
Incorrect use or reassembly may result in a risk of electric shock or fire.
26. Keep the charger away from children. Children do not understand or perceive
possible risks when handling electrical devices.
27. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the charger.
28. Do not charge battery packs when temperature is below 10 ° C (50°F) or above
40
°
C (104°F).
29. Do not attempt to use the charger as a step-up transformer, an engine
generator or DC power receptacle.
30. When the appliance is not in use and cleaning, unplug the appliance from the
outlet. before
31. Do not operate charger with damaged cord or plug.
32. Only operate the charger if all cables and the casing are intact.
33. Never operate the device if it has been dropped or damaged in any other way.
For inspection and repair, take it to a qualified electrician.
34. This charger belongs to type Y attachment, if the supply cord is damaged, it
must be replaced by the manufacture, its service agent or similarly qualified
persons in order to avoid a hazard.
35. All maintenance work must be conducted by qualified electricians.
36. Never disassemble the device, incorrect assembly may cause electric shock or
fire.
37. For the protection class is IP20. The product shall not be used outside the room,
where it is the rainy and snowy.