Villager ATLAS 4011 T, Original Instruction Manual, Page: 32 / 153

Villager ATLAS 4011 T / ATLAS 4111 T (GB)
12
CHANGING BLADES
To replace the blade, undo the screw.
Empty the oil tank before removing the blade
Reinstall as illustrated. Tighten the screw properly. Tightening torque 45 Nm.
When replacing the blade, the blade screw should also be replaced.
CHANGE OIL
1. Let engine runs out of out, and wait until engine
Stopped and cooled slightly.
2. Disconnect spark plug wire and keep away from
spark plug.
3. When engine is still warm, remove oil drain plug (A).
Drain oil into a proper container. (Fig.12)
4. Clean the oil drain plug before restoring it back.
5. Place engine level. Remove dipstick.Add new recom-
A
Mended oil about 0.3L slowly to upper limit on dip-
stick, don’t overfill.
6. Replace dipstick
Spark Plug
Once the engine has cooled, remove the spark plug and clean the plug with a wire brush. Using a feeler
gauge, set the gap to 0.75 mm ( 0.030”). Refit the spark plug taking care not to over tighten.