Villager ATLAS 4011 T, Original Instruction Manual, Page: 29 / 153

Villager ATLAS 4011 T / ATLAS 4111 T (GB)
9
ADJUST CUTTING HEIGHT
Raise wheels for low cut and lower wheels for deep cut, adjust cutting height to suit your
requirements. Medium position is best for most lawns.
BEFORE STARTING ENGINE ADD OIL
Before each subsequent use the oil level must be check and if necessary topped up with 500ml SAE30
engine oil.
OIL FILLER CAP/DIPSTICK
Your lawnmower is shipped without oil in the engine. For type and grade of oil to use, see “ENGINE” in
the Maintenance section of this manual.
CAUTION: DO NOT overfill engine with oil, or it will smoke heavily from the muffler on startup.
1.Be sure lawnmower is level.
2.Remove oil dipstick from oil fill spout.
3.Insert and tighten dipstick.
IMPORTANT:

Check oil level before each use. Add oil if needed. Fill to full line on dipstick.

Change the oil after every 25 hours of operation or each season. You may need to change
the oil more often under dusty, dirty conditions. See “TO CHANGE ENGINE OIL” in the Maintenance
section of this manual.
ADD GASOLINE

Fill fuel tank to bottom of tank filler neck Do not overfill. Use fresh, clean, regular unleaded gasoline.
Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure
fuel freshness.
CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.
FUEL TANK CAP
UPPER LIMIT
LOWER LIMIT