57
A
B
1
2
3
4
Embroidery Set Up
4
Hoop the fabric
For the best embroidery results, place a layer of stabilizer beneath
the fabric. When hooping stabilizer and fabric make sure that they
are smooth and securely hooped.
1. Open the quick release (A) on the outer hoop. Remove the
inner hoop. Place the outer hoop on a
À
rm
Á
at surface with
the screw on the lower right. There is a small arrow in the
center of the lower edge of the hoop which will line up with a
small arrow on the inner hoop.
2. Place stabilizer and the fabric, with the right sides facing up,
on top of the outer hoop. Place the inner hoop on top of the
fabric with the small arrow on the bottom edge.
3. Push the inner hoop
À
rmly into the outer hoop.
4. Close the quick release. Adjust the pressure of the outer hoop
by turning the retaining screw (B). The fabric should be taut
in the hoop for the best results.
Note: When embroidering additional designs on the same fabric, open the
quick release, move the hoop to the new position on the fabric and close
the quick release. When changing type of fabric, you might need to adjust
the pressure using the retaining screw. Do not force the quick release.
Slide on the hoop
Slide the hoop onto the embroidery unit from front to back until
it clicks into place.
To remove the hoop from the embroidery arm, press the grey
button on the hoop attachment and slide the hoop towards you.
