43
2
Sewing Mode
Bobbin thread low
Your machine stops when the bobbin is almost empty. Replace
the empty bobbin with a full one and close the pop-up message
by pressing the OK button.
Note: Continue sewing without closing the pop-up message if you want all
thread on the bobbin to run out.
Remove thread from under stitch plate and
in bobbin area
(Only on model 30)
When this pop-up appears you need to clean the area under the
stitch plate from thread and lint in order for the Selective Thread
Cutter to cut properly. Close the pop-up message by pressing the
OK button.
Check upper thread
Your machine stops automatically if the top thread runs out or
breaks. Re-thread the top thread and close the pop-up message by
pressing the OK button.
Main motor overload
If you are sewing on very heavy fabric or if the machine is
blocked when sewing, the main motor can get overloaded. The
pop-up message will close when the main motor and power
supply is secure.
The stitch cannot be programmed
This message is shown if you try to program or add a buttonhole,
bartack or taper stitch* or the sew-on-button stitch to a program.
All stitches in your sewing machine are programmable except for
these. Close the pop-up message by pressing the OK button.
The stitch cannot be saved
This message is shown if you try to save a buttonhole, bartack,
darning or taper stitch* or the sew-on-button stitch to My
Stitches. All stitches in your machine can be saved in My Stitches
except for these. Close the pop-up message by pressing the OK
button.
*Only on model 30
