Viking Designer DEDO530SS, Service Notebook

Page: 13 / 68

13
Clock and Timers
Digital Electronic Timing Center
The Electronic Timing Center is used to program
and control all timing functions. It has five display
and programming modes that are activated by the
four push buttons and the “SET” knob. Both the
Bake Time mode and the Min/Sec Timer mode
can be used to time cooking periods. These
features can be used at the same time when both
ovens are in use. Only the Bake Time and Self-
Cleaning modes shut the oven off automatically
when the timed program is over. One oven can
also be cleaned while timing foods in the other
oven using the Min/Sec Timer mode.
Setting the Time of Day
The time of day must be set before any other
program can be used. When the oven is first
connected to the power, the timer display will
show –:–.
SET
CLOCK/
PROBE
MIN/SEC
TIMER
SET
BAKE
TIME
START
TIME
To program the time of day:
1. Press the “CLOCK/PROBE” * button
once. 12:00 will be displayed with the
word SET in the upper right corner.
2. Turn the “SET” knob until the correct
time of day is displayed. AM and PM are
not indicated.
3. Press the “CLOCK/PROBE” button
again. The word SET will disappear and
the correct time is now set into the timer.
The time of day cannot be changed while there is
a Bake Time or Start Time cycle programmed into
the timer.
Setting the Min/Sec Timer
The Min/Sec Timer is designed for accurate
timing and can be used at the same time the Bake
Time or Start Time functions are in use. It can be
used for timing up to 24 hours. When setting the
timer, the time displayed will increase in 1 minute
increments. When the timer counts down to 1
minute, the timer alarm will give two short beeps
and the display changes from hours:minutes to
seconds only.
To program the Min/Sec Timer:
1. Press the “MIN/SEC TIMER” button. The
timer will display :00 and the word
TIMER will be displayed in the lower
right corner.
2. Turn the “SET” knob until the desired
duration time is displayed.
The Min/Sec Timer is now programmed. An
alarm will sound at the end of the countdown. The
program can be canceled anytime by setting the
remaining time to 00:00. To change back to the
time of day, press the “CLOCK/PROBE” button.
Notice that a small clock will be displayed in the
upper right corner to indicate that a program is in
progress. The display will return automatically to
the Min/Sec Timer after a few seconds.
Timer Alarm
At the end of a Min/Sec Timer program or Bake
Time program, the alarm will consist of three
beeps, followed by two beeps every 10 seconds,
until the “MIN/SEC TIMER” button is pressed.
Whenever a valid function key is pressed or when
a control function starts automatically, one beep
will be sounded. When an invalid function key is
pressed, two beeps will be sounded.