9
Assembly
5777744-03 GB Subject to technical changes!
Â
Drill a hole into the plate end of the opposing ele-
ment (
6
) through the hole provided (
7
) in the plate
surface of the spring side.
Â
Rivet the overlapping of the floor elements.
Drill holes
Â
Use a suitable lubricant for drilling.
L
Depending on the floor, make the drill holes according
to the specifications below.
1600 N floor:
Drill with Ø 3.3 mm
Drill hole at least 10 mm deep.
Pop rivet with Ø 3.2 mm
Hand riveter with mouthpiece (suitable for stain-
less steel) for 3.2 mm pop rivet
3000 N, 4000 N and 5000 N floor:
Drill with Ø 5.0 mm
Drill hole at least 24 mm deep.
Countersunk rivet with Ø 5.0 mm
Hand riveter with mouthpiece (suitable for stain-
less steel) for 5.0 countersunk rivet
4.7 Seal operating apertures in the cam locks in
the floor elements
L
Using a steel hammer will run the risk of contamina-
tion with outside rust.
Â
1
2
3
4
Fill operating aperture (
3
) with the supplied heat
insulation foam filler (
4
).
Â
Fill the operating aperture (
3
) by spraying it with the
enclosed sealant (
2
).
Â
Seal operating apertures (
3
) with plugs (
1
).
L
Use suitable plugs depending on the floor.
1600 N floor:
Plug Ø 15.0 mm stainless steel
3000 N, 4000 N and 5000 N floor:
Plug Ø 15.1 mm stainless steel, knurled
4.8 Assembling wall elements
Â
Make sure that the inner floor panel is free of grease
and dust in the area of the inner wall panel (
2
).
