Viessmann BW 301.B06, Installation And Service Instructions Manual

Page: 115 / 132

115
DHW
Parameter
Code Delivered condition Commission-
ing
Maintenance/
service
Set DHW temperature 6000 500 (
≙
50 °C)
Min. DHW temperature 6005 100 (
≙
10 °C)
Max. DHW temperature 6006 600 (
≙
60 °C)
Hysteresis DHW temperature heat pump 6007 50 (
≙
5 K)
Hysteresis DHW temperature booster heat-
er 6008 100 (
≙
10 K)
Start optimisation for DHW heating 6009 0
Stop optimisation for DHW heating 600A 0
Set DHW temperature 2 600C 600 ( ≙ 60 °C)
Temperature rise per hour for DHW heating 600D 30 K/h
Temperature sensor at bottom of DHW cyl-
inder 600E 0
Max. runtime DHW heating in heating mode 6011 240 min
Max. interruption of DHW heating for central
heating 6012 90 min
Enable booster heaters for DHW heating 6014 0
Enable electric heaters for DHW heating 6015 0
Priority DHW heating with combi cylinder 6016 0
Start attempts for DHW after high pressure
shutdown 6017 1
Shutdown hysteresis inst. heating water
heater 601E 0 (
≙
0 K)
Cylinder primary pump enable 601F 0
Operating mode cylinder primary pump 6020 0
Enable elec. heating/ext. HS for reheating
only 6040 0
Solar
Parameter
Code Delivered condition Commission-
ing
Maintenance/
Service
"Type solar control unit" 7A00 0
Parameters for solar control module, type
SM1 C0xx These parameters will only be displayed if the solar
control module, type SM1, is connected to the heat
pump and
"Type solar control unit" is set to "3" .
For a description of the parameters, see installation
and service instructions for "solar control module, type
SM1".
Commissioning/service reports
Control parameters report
(cont.)
5516461
Appendix