Viessmann BW 301.B06, Installation And Service Instructions Manual

Page: 113 / 132

113
Parameter Code Delivered condition Commission-
ing
Maintenance/
Service
"Use of heat pump in cascade" 700C 10
Runtime balance cascade 700D 0
Temperature range input 0...10 V, cooling
mode 700E 500 (
≙
50 °C)
External extension 7010 0
System components for external change-
over 7011 0
Operating status for external changeover 7012 2
Duration of external changeover 7013 8 h
Effect of external demand on heat pump/
heating circuits 7014 4
Effect of ext. blocking on heat pump/heating
circuits 7015 4
Vitocom 100 (type GSM/GSM2 only) 7017 0
Temperature range input 0..10 V 7018 1000
Priority external demand 7019 0
Effect of external blocking on pumps/
compressor 701A 0
Common flow temperature sensor system 701B 0
Operating status after message A9, C9 701C 0
Effect of OM changeover to ventilation 701F 3
"Select primary source" 7030 0
Start hysteresis solar air absorber 7031 20 ( ≙ 2 K)
Minimum temp. for solar absorber primary
source 7033
–
500 (
≙
–
50 °C)
Min. runtime to suppress summer mode 7035 60 min
Last calendar week for summer mode 7036 35
Absorber circuit monitoring 7037 0
Temperature sensor for dual mode opera-
tion 7038 0
Holiday program effect 7050 384
Compressor/Compressor 1
Parameter
Code Delivered condition Commission-
ing
Maintenance/
Service
Enable compressor 5000 1
Enable use of compressor stage 5012 15
Output compressor stage 5030 Rated heating output
according to type
plate
Primary source output 5043 0
Commissioning/service reports
Control parameters report
(cont.)
5516461
Appendix