U S E R ‘ S M A N U A L |
V I R O L L E R | 12
When attaching external resistance systems to the vibratory bar (elastic straps and/
or pulley machines) using its lateral anchors, be sure to use adequate snap rings.
Do not use the vibratory bar if the contact surfaces are worn out.
Once training is finished, stop the device using the principal switch and disconnect
the control tower when it is not going to be used for prolonged periods of time.
To store and move the
Viroller
turn off the principal switch located at the bottom of
the tower and disconnect the L-shaped connector from the control tower.
C O N N E C T I O N O F T H E V I B R A T O R Y B A R T O T H E C O N T R O L T O W E R
Once removed from the packaging, place the control tower near the sliding plat-
form so that the spiral cable is positioned near the connector. Connect the spiral
cable safety connector to the electronic control tower as shown in
Figure 5
. Plug the
power cable in to the power socket and turn on the principal switch.
