Videotec MAXIMUS MPXT, Instruction Manual

Page: 21 / 256

Instruc
tion manual - English - EN
19 MNVCMPXHDC_1916_EN
6.4.4 Fixing the unit to the pole mount
adapter or corner mount adapter
To install the product on the pole sling or on a corner,
first of all fix the support bracket.
Fig. 9
To fix the support bracket, use the 4 flat washers,
the 4 grower washers in stainless steel and the 4
hexagonal head screws in stainless steel (A4 class 70)
M10x30mm supplied.
Make sure the thread are free of dirt and debris.
Apply a generous amount of threadlocker (Loctite
270) on the 4 threaded holes on the pole mount
adapter.
Tighten the screws.
Pay attention to the fixing. Tightening
torque: 35Nm.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
To fix the device to the bracket, consult the relevant
chapter (6.4.3 Bracket mounting, page 18).
6.4.5 Sunshield mounting
Remove the protective film before the
sunshield installation.
Fix the sunshield to the housing using the screws and
washers screwed into the upper body of the housing.
Apply a generous amount of thread locking
compound (Loctite 270) into the threaded holes in
the base of the device.
The thread compound must cure for one hour, allow
for this period prior to completing the installation.
Fig. 10
Pay attention to the fixing. Tightening
torque: 2Nm.