Videotec HOV, Instruction Manual

Page: 11 / 84

Instruc
tion manual - English - EN
9 MNVCHOV32_1702_EN
6.5 Installation of the version
with double filter for air renewal
During installation pay attention to the
orientation of the air inlet filter fins.
Fig. 4
Depending on the angle of inclination of the housing,
the orientation of the filter fins must prevent water
penetrating in case of rain:
To guarantee weatherproof protection, install the
housing on the support following the inclination
limits as shown in the picture.
0˚
45°
45°
Fig. 5 Maximum tilt of the transversal axis: 0°.
Maximum tilt of the longitudinal axis: ±45°.
6.6 Installation of the version
with wiper
Open the housing as described in the relative chapter
(6.1 How to open the housing, page 7).
Identify the terminal of the wiper board.
P
S
C
Fig. 6
Connect the wiper board to the power supply mains
as shown in the figure.
P
S
C
L
N
~
Fig. 7
Nominal section of the cables used: from
0.2mm² up to 2.5mm².
Pressing the button activates the wiper. When the
button is released the wiper blade will return to the
rest position.
If you have a receiver with the Wiper control function,
connect the SW, PER and COM terminals respectively
to terminals S, P and C of the board.
6.7 Desiccant bag
Take the dessicant salt bag out of its pack and insert it
into the product.