•
Start after condition is reached for:
Set a delay before auto-start. Some AC device will draw a short-term, high-peak current
on start-up. Instigating a delay before auto-start will avoid starting the generator unnecessarily.
•
Stop when battery current is lower than:
Set the current for auto-stop.
•
Stop value during quiet hours:
has been defined, set a higher current level to achieve shorter generator run-
times.
•
Stop after the condition is reached for:
Set a delay to ensure that the current-reduction condition is stable.
Relays triggered by Battery Voltage
•
Use battery voltage value to start/stop:
Toggle the feature on or off.
•
Start when battery voltage is lower than:
When battery voltage falls below the value entered the relay will start the generator.
• Start value during quiet hours: If
has been defined enter a lower (more critical) value to ensure the generator will
only auto-start when absolutely necessary.
•
Stop after the condition is reached for:
This feature builds in a delay before stopping the generator after the 'stop' value has
been reached. This is to make sure that the voltage rise is stable.
Relays triggered by AC load
AC load triggers work similarly to other triggers but the feature is refined by a Measurement setting.
The Measurement setting is available on firmware v2.0 and later and has three possible values:
Total consumption (Default option)
Inverter total AC out
Inverter AC out highest phase
Relays triggered by Inverter High temperature
•
Start on high temperature warning:
Toggle this feature on or off.
•
Start when warning is active for:
Set a delay to avoid temperature rises which are temporary, caused by brief high AC
demands.
•
When warning is cleared stop after:
Set a delay to ensure that a reduction in inverter temperature - usually caused by lower
power demand - is stable.
Relays triggered by Inverter overload
•
Start on overload warning:
Toggle this feature on or off.
•
Start when warning is active for:
Set a delay to ensure that the inverter overload warning has not been triggered by a high-
demand of AC power of only short duration.
•
When warning is cleared stop after:
Set a delay to ensure that the reduction in AC power demand is stable.
Color Control GX Manual
Page 60
GX - Generator auto start/stop
