Vicking electronics
Pag. 8
Mounting
The timemate is mounted to the wall with a special mounting plate. The timemate hooks into the
bent upper part of the plate and is then fixed to the plate with 2 screws. These screws are
accessed by removing the bottom lid of the timemate.
Look at the end of this manual for to see the dimensions of the wall plate and where you can
make a hole to guide the cables.
The cables to the timemate can go through the back of the timemate and then through the wall.
Or the cables can go through the bottom of the timemate with cable glands.
If you drill a hole for cables in the TIMEmate and you still want to keep the IP54 waterproof
protection you need to use watertight seals like cable grommets and cable glands.
The cables of the TIMEmate can go trough the back of the TIMEmate and then trough the wall
or the cables can go trough the bottom of the TIMEmate.
You can use a cable grommet or a cable gland for each cable with an IP54 protection for cables
with a diameter ranging from 3.5 to 8 mm (PG9).
If you use a cable grommet it is recommended to use a strain relief on the cable.
Cable gland
Grommet
