Vicking electronics
Pag. 13
Timemate IIIB setup menu
Press during reset
Hold 5 sec
Standard keyboard
To get into the setup menu.
Press and keep pressing the upper left key on
the keyboard, then press and release the reset
button.
The reset button is located on the left side of the processor board (see the drawings at end of
manual). You can also switch the power to the TIMEmate off and on.
If resetting the TIMEmate is not practical. You can also get into the setup menu by pressing the
‘
.’
key for 5 seconds during normal operation. You then need to enter the
password 1596.
1=Setup menu.
By pressing the up arrow go to the next menu item.
By pressing the down arrow go to the previous menu item.
By pressing enter you change the current setting.
By pressing the backspace key you leave the setting menu without saving the changes.
Set TIMEmate terminal address
Address 00 is the default setting.
This address is mostly used for multidrop RS485 communication (see next setting)
Set RS485 Multidrop mode.
0=No RS485
The communication is always active (RS232 of Ethernet)
1=Activate RS485 The communication is active if the terminal address is used. (RS485)
Set Real Time Clock
