10
3.1.2
Procedure for installing the separate type balance
To use the display and the balance separately from each other
Lift the pan, and slide it backward.
Slightly open both sides of the cable cover, and mount it vertically in the cable housing.
Mount the base cover in the front of the cable housing so that it is hooked on the cable cover.
Put back the pan.
In order to level the balance, turn the adjusters so that the air bubble is centered in the viewer.
To integrate the display with the balance
Lift the pan, and slide it backward.
Loosen the two knobs in the connecting fitting, and mount it vertically in the cable housing.
Check that the supporting boards are hooked on the bottom of the cable housing.
Fasten the two knobs in the connecting fitting.
Fold the cable and put it in the cable housing with 15 cm of the cable left unfolded in the
display end.
Slightly open both sides of the cable cover, and mount it vertically in the cable housing.
Insert the display in the connecting fitting at an angle.
Put back the pan.
Mount the base cover vertically.
In order to level the balance, turn the adjusters so that the air bubble is centered in the viewer.
* Numbers in the figure correspond to
the above steps to install the balance.
Position of the air
bubble in the level
Adjuster
Cable housing
Base cover
Cable cover
Cable cover
Display
Cross-section View of Connecting Fitting Installation
Base cover
Knob
Cable housing
Adjuster
(Connecting
fitting)
Supporting board
Pan
Knob
Cable housing
Supporting board
