39
11.8
Interval Output Function
This is a function to output data at intervals. You can also output data with the current time. Set an
interval in Hour-Minute-Second format. To use the interval output function, enable it in Function 1
[
] or [
].
11.8.1
Set interval output
1 Call the interval function.
Press the Set key until the display indicates a series
of dots [
]. The display indicates an
interval with the leftmost digit blinking.
2 Set an interval.
Press the Zero/Tare key to change the blinking
value, and the Function key to blink the next digit to
the right. If you press the Function key when the
rightmost digit is blinking, the leftmost digit blinks.
(You can use the arrow keys instead. Refer to page
24).
3 Save the settings, and go back to
measurement mode.
Press the Set key to return to measurement mode.
When you press the Print key before saving an
interval, the original interval is displayed.
If you press a key other than the Set key here, the
balance goes back to measurement mode, but the
settings are not saved.
11.8.2
Start interval output
Press the Print key. The display indicates a series of dots [
], and starts interval output.
A dot [
] blinks during interval output. A dot [
] lights up when data is output.
11.8.3
Stop interval output
Press the Print key. The display indicates [
], and the balance goes back to measurement
mode.
Caution:
1.
Data may not be output at exact intervals because output is stopped when Function 1 or
Function 2 is displayed.
2. A series of dots [
] may be displayed when you set an interval. This indicates that
the interval is too short. In this case, you should set an interval again.
Continuous press
：
：
