80
Vertiv I Liebert ITA2 30kVA I Manual
6.6
Connecting Built-in Ethernet Port
The built-in Ethernet port supports the HTTP protocol. The user can connect one end of the
network cable to the Ethernet port of the UPS, and connect the other end to the built-in
Ethernet port of the computer. The user can remotely access the UPS via the IE, Chrome and
Firefox, so as to monitor the UPS in real time.
Connect network cables: Connect one end of the network cable to the Ethernet port of the
UPS, and connect the other end to the built-in Ethernet port (or the switch port, Router port)
of the computer.
Set network parameters: The user should change the parameters (IP address, subnet mask,
gateway address) of the computer or the UPS, so as to make the computer communicate the
UPS well.
To change the network parameters of the UPS, operate them via the 'Settings'->’Monitor’, as
shown in Figure 6-4.
Webpage monitoring function
Open the browser (like IE), input the IPv4 address at the address bar to the login interface.
After inputting the correct user name and password (default name: user, password: 111111),
you can monitor the UPS working status.
Change settings password
Modbus address
1
Output
Battery Monitor
System
Figure 6-4
Changing UPS network parameters
Browser support
To obtain the best user experience, it is recommended to use the Internet Explorer (IE9 or
above), or the Chrome, FireFox (latest version required)
Screen resolution
The display with resolution of 1024*768 or above is recommended.
