Vertical WAVE IP 2500, Hardware Reference Manual

Page: 3 / 210

R e v i s i o n H i s t o r y
Release Date Documentation Changes Page No.
2.0 SP1 04/11 Corrected model numbers as needed. Throughout
Updated Caution to indicate that no modules or cards are hot-swappable . 3-5
Updated Caution to emphasize that the exterior ground lug should always
be properly connected .
3-5
Corrected the order of steps 1 and 2 in “Local system power-on.” 3-6
Corrected the order of steps 1 and 2 in “Installation verification.” 4-9
Added Caution about location of hatch cover insulation strip when
replacing the Backplane Terminator Board or adding another EXU.
6-6
Clarified that on the Wave IP 2500, you can use Expansion Units (EXUs)
to support more analog trunks and/or analog stations than can be
supported by analog cards or modules .
9-2 , 14-2
Clarified usage of USB1 and USB2 ports on the ISC1 (Wave IP 2500
Server only).
12-13
Clarified usage of ENET1 and ENET2 ports on the ISC1 (Wave IP 2500
Server only).
12-14
Added section describing the 2 configurations supported by the
8+8 Port
Analog Universal Module (VWU-8X8AU-M).
14-2
Added Caution stating that the rocker switch at the rear of the Wave IP
500 Server should be only be used to power off the Server failed to shut
down normally .
18-8
Clarified usage of USB1-3 ports on the ISC2 (Wave IP 500 Server only). 18-14
Added entry for “Embedded firmware had too many failed boot attempts”
error to the Early Boot Error table of LED settings.
E-19
Release 2.0 Service Pack 1 April 2011