Vertical WAVE IP 2500, Hardware Reference Manual

Page: 103 / 210

Ports 12
-
13
Chapter 12: Integrated Services Card 1 (Wave IP 2500 only)
Wave Server Hardware Reference Guide
Ports
Telephony ports
An RJ-21X connector provides the following:
• 4 analog station ports (FXS) provide telephone service for up to 4 telephony devices,
including telephones, fax machines, and modems.
• 4 analog trunk ports (FXO) provide for connectivity to PSTN lines. These ports support
loop-start trunk types only.
Ethernet network ports
Two RJ-45 ports (ENET1 and ENET2) provide Ethernet connectivity.
Important: Only the port labeled ENET1 should be used in any Wave installation. Do not
connect the ENET2 port to the network unless you are specifically directed to do so by your
Vertical support representative.
Audio ports
Two audio ports (one input, one output) provide connection to audio peripherals, such as a
music-on-hold device and a paging/public address system. The ports are standard 3.5 mm stereo
connectors. See “Cable connections” on page 12-14 for an important note about cable
requirements when connecting a music-on-hold device to the Wave Server.
USB ports
There are 2 USB ports on the ISC1 that perform different functions:
•
USB1 (top port)
is wired to the Wave Server’s embedded processor and will never be
accessed or used by anyone other than Vertical's engineering staff. USB1 cannot be used
for any field-serviceable operations.
Important: Do not connect any devices to USB1.
•
USB2 (bottom port)
is the only port a service technician can access or use for
field-serviceable operations.
Release 2.0 Service Pack 1 April 2011