Vertical WAVE IP 2500, Hardware Reference Manual, Page: 170 / 210

Menu options A
-
8
Appendix A: Fault Monitor Module and Trace Log
Wave Server Hardware Reference Guide
These values indicate whether power supplies 1 and 2 are operational. The value 0 means the
power supply is not functioning properly. The value 1 means the power supply is OK.
Watchdog timer status
The watchdog timer is always running. However, the status of “enabled” or “disabled”
determines how it responds when a time-out occurs.
L - List trace log
Entering cli l after the DBG prompt, lists the following options:
• m (main screen): lists the full 32K main buffer
• l (last 4K): lists only the last 4K of traces in the main buffer
W - Watchdog timer
Entering cli w after the DBG prompt, displays the watchdog timer settings, as shown in Figure
A-5.
Figure A-5
Watchdog timer
To change watchdog timer settings:
1. Enter cli w after the colon on the command line to invoke the watchdog timer option.
2. Enter cli y after the Change Settings? prompt. The prompt Page on time-out (y or n): is
displayed.
3. Enter cli y or cli n. This selection has no effect on this unimplemented feature. The
prompt Reset on time-out (y or n): is displayed.
4. Enter cli y or cli n. The command line colon is displayed.You can enter cli w again to
confirm your selections.
cli w
Watchdog enabled: Page=N, Reset=Y.
Change settings? (y or n)
Release 2.0 Service Pack 1 April 2011