Vertical WAVE IP 2500, Hardware Reference Manual

Page: 104 / 210

Cable connections 12
-
14
Chapter 12: Integrated Services Card 1 (Wave IP 2500 only)
Wave Server Hardware Reference Guide
Pre-charge port
The Pre-charge port is reserved for future use.
Cable connections
Ethernet, telephony, and audio cables can be plugged into the ISC1 as described in the following
sections.
10/100Base-T Ethernet switched connections
Up to two Ethernet cables can be plugged into the RJ-45 connectors located on the ISC1.
• Only ENET1 should be connected to your network.
• ENET2 should only be used if you are directed to do so by your Vertical support
representative.
Warning:
Under no circumstances should both connectors be connected to the same switch
or LAN segment. Doing so will result in a loss of connectivity to the Wave IP 2500 Server.
Telephony connections
One RJ-21X cable plugs into the RJ-21X connector located on the ISC1.
Warning:
To reduce the risk of fire, use minimum 26 AWG line cords that have been
evaluated as Communication Circuit Accessories, UL 1863, for all telephone connections.
Audio connections
One audio output device (such as a paging or public address system) can be plugged into the
audio output port. One audio input device (such as a music-on-hold system) can be plugged into
the audio input port. These ports are shown in Figure 12-1.
Note: You must use a cable with a stereo plug to connect your music-on-hold device to the
Wave Server chassis. If this cable is not provided with the device, you need to purchase a
separate cable. For more information about connecting audio devices, refer to Appendix B,
“Connecting Audio Devices.”
Release 2.0 Service Pack 1 April 2011