Vertical Express ICON 32, Product Manual

Page: 79 / 220

ADJUSTMENT
Vertical Express Product Manual 2-39 88500 v.1.0
Adjustment Section Operational Adjustments
Electronic Starter
(continued) 7. Press

once to access the value.
a. Press

or

to adjust the value of the flashing digit.
b. Press

to move to the next digit.
8. Press

to exit to the
PARAMETERS
Menu.
A prompt to
ACCEPT
or
REJECT
the change appears. Press

to accept,
or

to reject and correct the parameter.
Operational Adjustments
Configure the THY02 Card
The THY02 Card, powered by 24VDC, is a receive-only device. See Figure 12.
• REC+ and REC- are for 485 communication protocol.
• CANH and CANL are for CAN communication protocol used with ICON32.
1. Set the S1 Dip Switch #3 to the ON position.
2. Set the controller adjustment O43=9 for the Car CAN Channel (CCL/CCH).
3. Issue a WRT Command.
4. Press
RST
on the CPUC Card.
Figure 12 - THY02 Card and Dip Switch Functions
Function
Dip
Switch
ON = Self-test Mode. Unit ignores data link inputs. 1
ON = Use 50 kHz CAN link.
3
OFF = Use 100 kHz CAN link.
ON = Use MAMMI Message 8 as play strobe for voice. 4
ON = Unit display alternately shows lower two ASCII characters of
floors and messages. When displaying a message, “100” LED is lit.
5
ON = Unit display shows floor position number instead of ASCII
characters.
6
ON with EEPROM installed = Activate the passing chime when the bit is
set in EEPROM for that floor position number.
7
ON = Activate floor number redundancy (need same data twice). 8