Vertical Express ICON 32, Product Manual

Page: 9 / 220

INSTALLATION
Vertical Express Product Manual 1-5 88600 v.1.0
Installation Section Preliminary Installation
Installation
(continued)
Configure the UPS
1. When on temporary operation, connect the following:
a. The AC receptacle cord from the IOF Card - CON18, pins 1, 2, and 3.
b. The AC plug from the IOF Card - CON18, pins 4, 5, and 6.
• The UPS should not be in the AC circuit during temporary operation. See
Figure 3.
• If battery lowering is not required for the job, no UPS will be provided.
• When battery lowering is not present, Manufacturing installs jumper wires
from CON18 pin 1 to pin 4, pin 2 to pin 5, and pin 3 to pin 6 on the IOF Card.
• The UPS may be mounted below the controller - Use the shipping bracket
and screws to hold the UPS in place, and wire the plug through a knock
out in the bottom of the controller.
Figure 3 - UPS Unit Connections
2. Use a temporary jumper to connect EPD1 and EPD2 (located in the Trades
Access Panel, on the top of the controller). See Figure 4.
The EPD1 and EPD2 jumper will be replaced by an auxiliary set of contacts in the dis-
connect to prevent the control system from operating on any form of alternate power
when the disconnect is in the OFF position.
Figure 4 - EPD1/EPD2 Jumpers
EPD1 & EPD2
Jumpers