Video Interfaces
EPM-19 Hardware Reference Manual
40
BIOS Settings for Boot Display Devices
Table 19: BIOS Settings for Boot Display Devices and Corresponding Resolutions
BIOS Setting for
Boot Display Device
Resolution
VBIOS
Determined by VGA display device (when
VGA connected) or set to 800 x 600
CRT
Determined by VGA display device
Panel0
640 x 480
Panel1
800 x 480
Panel2
800 x 600
Panel3
1024 x 600
Panel4
1024 x 768
Console Redirection
The EPM-19 can be operated without using the on-board video output by redirecting the console
to an available COM port. In the BIOS Setup utility, the Remote Access Configuration sub-
menu provides the ability to control console redirection. When console redirection is enabled,
you can access the BIOS Setup utility by typing <Ctrl>-<C>.
The default settings for the redirected console are as follows:
Serial Port Number: [COM1]
Base Address, IRQ: [3F8h, 4]
Serial Port Mode: [115200, 8, n, 1] (115,200 baud, 8 data bits, no parity, 1 stop bit)
Flow control: [None]
Terminal Type: [ANSI]
Figure 23 shows the wiring for a DB9-to-DB9 adapter for console redirection of an RS-232 serial
port.
Figure 23. Wiring for a DB9 to DB9 RS-232 Adapter for Console Redirection
