RFS INSTALLATION INSTRUCTIONS
VERIZON HYBRIFLEX CABLE| Revision 1 | APRIL 2019
Visit
for the most current product specifications
Page 3 of 33
Introduction to HYBRIFLEX
RFS’ HYBRIFLEX Remote Radio Head (RRH) hybrid feeder cabling solution combines optical fiber and DC
power for RRHs in a single lightweight cable, making it the world’s most innovative solution for RRH
deployments. It was developed to reduce installation complexity and costs at macro sites. HYBRIFLEX allows
mobile operators deploying RRH architecture to standardize the RRH installation process. HYBRIFLEX
combines optical fiber, power, and alarm wire in a single jacketed cable and can connect multiple RRHs with a
single feeder. Standard RFS CELLFLEX
®
accessories can be used with HYBRIFLEX cable. Both pre-terminated
and on-site terminated options are available.
The rugged jacket facilitates easy transportation, handling, and installation.
These short instructions were written for qualified and experienced personnel. They describe, in few words,
the main points that MUST be noted during installation, without any claim of completeness.
Any liability or warranty for results of improper or unsafe use is disclaimed!
General remarks:
In principle, care must be taken to avoid all such strain that may cause permanent deformation on the cable,
e.g. going below admissible bending radii, kinking, applying too high tensile stress or forcible deformation (e.g.
pulling over sharp edges, over tightening of clamps etc.).
Click or scan to learn more
about RFS HYBRIFLEX®
