RFS INSTALLATION INSTRUCTIONS
VERIZON HYBRIFLEX CABLE| Revision 1 | APRIL 2019
Visit
for the most current product specifications
Page 19 of 33
1-1/4 |1-5/8 inch armor cutting tool instruction
The following instructions can be use for 1-5/8” HYBRIFLEX’s cable. Note, the cutting tool are special design,
an off the shelf pipe cutter from local hardware should not be use. Note:
This is not a combo tool; size must be
purchased as either 1-
5/8” or 1-1/4”,
To use the HTPT’s cutting tool to cut the outer armor,
1)
Using the jacket striping tool remove the jacket off the cutting section
2)
Turn the turning knob counter
clockwise all the way until the tool is
completely open (Figure 2).
Warning!
Do
not try to release the latch, it is locked in
place. The blade can only be move in and
out by tuning the knob.
3)
Insert the cable between roller 1
and 2 as shown in figure: 2.
4)
Grasp cable and tool together with
one hand as shown in figure: 2a
5)
Slowly spin tool around the cable
while rotating the knob continue until the
aluminum armor cut through. As shown in
figure: 3, 3a
7/8 |5/8 inch Armor cutting tool
Instruction
