RFS INSTALLATION INSTRUCTIONS
VERIZON HYBRIFLEX CABLE| Revision 1 | APRIL 2019
Visit
for the most current product specifications
Page 17 of 33
Set the JSTRIP onto a straight part of cable. (a)
Insert a screwdriver into the two support holes and begin turning, maintaining a straight line – do not
push in any lateral directions and do not twist or leave the right angle line. Continue turning by hand
(the screwdriver is needed for the start only) until the jacket is cut completely around, still maintaining
a straight line. (b)
Make a mark onto the cable jacket in a distance of 70mm (2.75in) from the beginning of the first cut
(that’s 50mm (2.0in) which is needed for the grounding kit installation and for the part of the tool
from the end of the cutting edge to the end of the tool.(f)
Put the tool onto the cable again, whereby the cutting edge should be in the already jacket stripped
area. Start again, while pushing the tool slowly in direction of the marking. The jacket will be cut in a
spiral. Turn further by pushing the tool very slowly until reaching the marking. If the tool is on the
mark, turn further, but now push a little bit in the reverse direction in order to finish the cut in straight
line.(e/g)
Note: If the tool has been started to cut in a spiral, the tool will move continuously by itself in the same
direction. If the marked area is reached, this movement has to be stopped by pushing carefully in the opposite
direction. To develop the proper technique, we recommend testing on a part of cable, which is not needed for
