Veritas
9000A5
Commissioning
10
Mounting the presser foot holder
– Lift up the presser foot rod with the presser foot lift (a)
– Mount the presser foot holder (b) and affix with the screw
Using the presser foot
– Lower the presser foot holder (b) until the recess (c) lies directly over the pin (d)
– Press the attachment lever (e) upwards
– Lower the presser foot holder (b) and the presser foot (f) will automatically click into place
Removal of the presser foot
– Lift up the presser foot rod
– Press the locking lever (e) upwards until the foot is free
Attaching the seam guide
– Push the seam guide (g) as shown through the opening. Set depending on the required width
of the hem, the pleat etc.
Changing the needle
Change the needle regularly especially when it is worn and causes problems.
Insert the needle as shown in the following illustrations.
A.
Unscrew the needle clamp screw and tighten again after inserting a new needle.
The flat side of the shaft should be at the back.
B.
Push the needle up as far as it will go.
Only use fully-functional needles:
Problems can occur with:
– Bent needles
– Blunt needles
– Damage points
Note:
− Switch off the sewing machine (set the main power switch to «
0
»)
A
B
Mounting the presser foot holder
Using the presser foot
Removal of the presser foot
Attachment of the seam guide
Changing the needle