The SBH UI scales to the device you are using. The main menus and screens are side-by-side on a
computer screen or tablet. On a phone display, you see either the menu or the screens you selected
from that menu, for example, the TEC3000
Home
screen. When you view the UI on a phone or
smaller tablet, drag the screen from the left or right to display the required menu or screens.
Supported controllers
The Verasys system supports the following controllers:
• Zone and Bypass Damper controllers
• VAV box controllers
• Verasys Equipment and Application controllers
• Smart Equipment controllers
• TEC30xx/TEC36xx Thermostats
• Terminal Unit controllers (TUC and ATC)
• PENN
®
A52x refrigeration controllers
• Third-party BACnet controllers
In the following sections you can read about the controllers in more detail.
Zone and Bypass Damper controllers
The Zone Damper (ZEC310) and Bypass Damper (BYP200) controllers are components of the
Verasys zoning system. The Zone and Bypass Damper controllers run a pre-engineered HVAC
zoning application and provide the inputs and outputs required for this application. These
controllers are factory-configured for field installation on a zone or bypass damper assembly when
they are shipped.
The Zone and Bypass Damper controllers include advanced operating modes and multiple features
that ensure occupant comfort. A carbon dioxide (CO
2
) demand controlled ventilation (DCV) mode
in the Zone Damper regulates CO
2
levels within a zone by adding fresh air into the zone during
occupied times. The controller uses occupancy sensing capability to switch from occupied mode to
standby mode based on local activity. To maximize energy savings, standby mode uses setpoints
that are higher than the occupied cooling setpoint and lower than occupied heating setpoint.
VAV box controllers
The VAV box zone controllers run a pre-engineered HVAC zoning sequence and provide the inputs
and outputs that the VAV application requires.
The ZEC510 controller contains multiple features to ensure occupant comfort. Because of an
optional occupancy sensing capability, the ZEC controller can switch from occupied mode to
standby mode based on zone activity. To maximize energy savings, standby mode uses setpoints
that are higher and lower than the occupied mode setpoints.
The ZEC510 controller also uses plug-and-play technology to detect the connected network sensor
types.
To commission VAV controllers, you can use the Verasys SBH, the MAP Gateway, or the VAV
Balancing Thermostat.
Verasys System Product Bulletin
10
