Draft 3
Printed: 09/07/2003
Page 10
doc: icu_kit_user_maunul_090703.doc
3.1.2 Part Set arming the system (Omitting Zones)
Quick key sequence
Press the following keys:
Press
Ö
exit protected area
Detailed Explanation
Press the following keys:
Press
Exit countdown commences and the control unit beeps slowly displays shows
“
p 3
“
During the last 10 seconds of the exit countdown, the beeping gets faster as a final warning
to leave the premises.
Once armed, the display on the control unit will go blank and the external strobe will activate
for 5 seconds confirming the system has set after you have left the premises
If the users attempts to set the system while any zones are open the control unit will provide a bad bleep and return to
day mode, to set the system ensure all windows and doors closed and set the system.
During the exit timer if any “Entry / Exit” zones or “walkthrough” zones are triggered they will be ignored, if any instant
zones are triggered the alarm system will activate a local alarm, sounding the internal sounders, to silence the alarm
the code will need to be entered to cancel the activation. Exit timer is factory set at 30 seconds.
3.1.3 Disarming System into “Day / unset”
When the system is in “
Day / unset
” mode it is used for when the user is in residence and requires no intruder alarm
protection.
Quick key sequence
Press the following keys:
Press
system is unset
Detailed Explanation
Enter the premises or protected area first passing through “Zone 1” or any entry/ exit / zones, The control unit will
begin to beep slowly indicating that you must disarm the alarm system within the entry exit time (30 seconds default
entry). As with the exit timer, these beeps get faster in the last 10 seconds of the entry time.
During the entry timer walkthrough zones will also act and entry exit zones also known as time inhibited zones.
Press the following keys:
Press
OK beep, and display shows
“
0 0
”
flashing, for 1 minute.
In “
Day / unset
” mode the PA and all tamper are still active.
The wireless remote control can also unset the system from out side of the premises in some circumstances it may be
desirable to disable this feature, this must be done via engineer programming. If remote disarming is disabled to unset
the system the user must first start the entry timer by passing through zone 1 or any or entry / exit zone, then the
wireless remote can disarm system.
P
P
U
U
