Draft 3
Printed: 09/07/2003
Page 3
doc: icu_kit_user_maunul_090703.doc
1.0 Using the System
1.1 An Overview
The ICU system may be set and unset by utilising either the on bored key pad on the control unit
or by utilising a wireless remote control, which can also act as a Personal Attack button. The on
board key pad is also used to program and change system features and settings.
ICU 23 key Pad
ICU Wireless Remote Control
Setting and Un-setting the System
The system has four set levels “
Full set
”, “
Part set 1
” , “
Part set 2
” and “
Part set 3
”, when no
protection is required the system is “
day / unset
”.
The System has two user codes, the master user code which is “
1234
” and the standard
secondary user code which is “
5678
”. The Secondary user code is not enabled by factory default,
and must be enabled by the engineer before it can be used.
Both user codes can be used to set, unset and reset the system, but only the master user code
can make programming changes to the system.
Code Protection
Incorrect code entry is protected with an automatic keypad lockout, should the code be entered
incorrectly Five times the key pad will lockout for 1 minute, and will not respond to key presses. If
this occurs wait 1 minute then re-enter the correct code.
Programming and Enabling Features.
The ICU W16 has many programmable features allowing the user to personalise the system, such
as programmable user and secondary user codes, chimes zones,
Walk testing
At regular intervals the system should be fully tested by walk testing the intruder detection devices
and remote PA devices, testing the external sounder and strobe unit and testing any signalling
devices such as digital dialling devices.
