HAM841K GB
3
7. Panic
Button
:
Connected internally to the 24hr instant-alarm circuit. Pressing this button will activate the siren, regardless the
position of the key switch.
LED INDICATIONS
•
Exit / Armed (GREEN) :
This LED indicates the status of the alarm. The exit period (60 sec.) begins when the key switch is put in the "on"-
position. The LED will flash and will then remain lit continuously when the exit period ends. The Exit/Armed LED will be
extinguished if either the instant-alarm circuits or delayed-alarm circuits are activated (RED). The function of this LED is
duplicated on terminal 4 so that remote indication can be used.
•
Instant-alarm Circuit LED (RED) :
This LED will light whenever either of the instant-alarm circuits (24hr or N.C.) is operated while the key switch is in the
"on"-position.
•
Delayed-alarm Circuit LED (RED) :
This LED will light whenever either of the delayed-alarm circuits (N.O. or N.C.) is operated while the key switch is in the
"on"-position.
•
Alarm Memory LED (GREEN) :
This LED will light when the alarm is triggered and will remain lit until the main power switch is turned off or until the key
switch is turned "off-on-off". The alarm was triggered in your absence if this LED is lit.
•
Battery-Low LED (GREEN) :
This LED will flash once every 2 sec when the battery voltage drops below 11.5 Volts.
•
AC Power LED (AMBER) :
This LED indicates that power is supplied to the panel (main power switch is in the "on"-position). It should remain lit
continuously. The backup battery will supply the necessary power if the main power switch is in the "on"-position and
this LED is not lit. Restore the primary power source as soon as possible.
INTERNAL WARNING TONES
Exit Delay Period*
- Short "BEEP" at 1/2 second intervals
Entry Delay Period
- 2-second "BEEP" at 1/4 second intervals
Battery-Low Indication
- Short "BEEP" at 2-second intervals
Alarm Test Mode
- 2-second "BEEP" at 1/4 second intervals
Tamper Alarm
- 2-second "BEEP" at 1/4 second intervals (Short 20-21 to deactivate the alarm)
Horn Speaker Wire Is Cut - 2-second "BEEP" at 1/4 second intervals (1K resistor between 11-12 to deactivate the alarm)
* if terminals 11 & 12 are connected by a 1K
Ω
resistor
