Vedeneyev M-14P, Maintenance Manual, Page: 297 / 381

TO M-14P MS
TASK CARD No. 204
MS ITEM
PROCEDURE
:Replacement of Magneto Distributor and Ignition Harness Cables
OPERATIONS AND TECHNICAL REQUIREMENTS CORRECTIVE
ACTIONS
CH
ECKED BY
1, Carry out operations under Items 1 through 4 (Ref. Task Card No. 203),
2, Loosen screws (27) (Ref. Fig. 1) for attachment of ignition cables to the contacts of
distributor (22).
3. Remove leads from the socketa of distributor (22),
4. Install the wire leading to the spark plug of cylinder Ho* 9 into the socket of the
distributor LH projection (Ref, Fig. 201).
5. Install wires along the direction of arrow LH ROTATION on the distributor to spark plugs
of cylinders 2, 4, 6, 8, 1, 3, 5, 7 which corresponds to the following mixture firing order in cylinders
1, 3, 5, 7, 9, 2, 4, 6, 8.
6. Stop spare socket P with a length of wire.
7. Tighten screws (27) (Ref, Pig. 1) for attachment of ignition cables to
contacts of distributor (22).
NOTES: 1. The RH magneto leads run to the rear spark plugs, those of the LH magneto,
to the front ones.
2. Connect the leads to the magneto selector switch as follows: c/ith the selector switch
knob in position "O", both magnetos should be cut out. With the selector switch knob in position "1"
or "LH",the LH magneto should be cut in and the RH one should be cut out