Vedeneyev M-14P, Maintenance Manual, Page: 141 / 381

154
OPERATIONS AND TECHNICAL REQUIREMENTS CORRECTIVE ACTIONS
CHECKED
BY
6. Install the engine on the airplane: (1) Install the airplane braces on the
engine frame ring. (2) Bring the engine with braces to the airplane.
(3) Insert four brace-to-airplane attachment bolts having made sure they are intact,
(4) Install the washers. Screw on and. uniformly tighten the nuts;
cotterpin them.
7. Install the airscrew pitch control brackets on the engine, using the following procedure:
(1) Undo the gearbox-to-intermediate crackcase attachment nuts near the airscrew pitch
control brackets and two nuts for attachment of the R-2, series 04 speed governor.
(2) Install the airscrew pitch control brackets on the studs, place spring washers, install and
tighten the attachment nuts of the gearbox and R-2, series 04 speed governor.
NOTE: Tighten the nuts for attachment of the gearbox to the intermediate
crankcase and fastening the airscrew pitch control brackets with a
torque wrench 14-024-260 with socket 14-324-06. Tightening torque is
(1,5
+0,3
) kgf-cm.
8. Install the airplane lever on the control shaft of the R-2, series 04 speed governor to
which end:
(1) Undo the nut and remove the washer from the governor control shaft* (2) Install the
lever and washer on the governor control shaft. (3) Install and tighten the nut, lock it with
a cotter pin.
9. Connect the oil, fuel and air lines with the respective connections on the engine and lock
them.