9
AW DX22CE
Installing Wall Bracket
1. Remove the eight screws indicated by arrows in figure 1.
Figure 1.
Figure 2.
5. The deflector can be reversed 180° if the indoor unit has a low
position (at least 850 mm above the floor) or if the air should be
directed upwards. Remove the six screws and turn the deflector,
see figure 5.
2. Install the wall brackets in towards the fan with the marked holes as per figure 2. These holes are used for cable ties for the
fan motor cable.
3. The indoor unit must be installed with the transport protection for the pipe connections to the left. Make sure that it is
level both along its width and its depth, see arrows on figure 3.
Figure 3.
Figure 4.
Figure 5.
4. Remove the four screws that hold the transport protection with a Torx 20 screwdriver, see figure 4. Remove the protection
and put the screws back.
