VDO OCEANLINK -, Operating Instruction

Page: 71 / 204

Connector 2 sensor types
Note : the underlined value/command is the default value/command. The units of measure depend on
parameter SYSTEM CONFIG > Units
Setting Description Possible values/commands
Frequency pin 4 Impulses per engine revolution. If
enabled, engine revolutions are read
by the analog frequency sensor. Off / On
Show value as : Engine 1 - 4. Connected engine ID*
Pulse per revolution : 0.0 – 655.34 (1.0). Offset factor to
calculate the engine revolution number based on the frequency
signal value.
Voltage pin 7 Input 7 sensor Input :
l
Off : no connected analog sensor
l
Ext illum : brightness control (day-night) from external
control
l
Engine oil pres 0 - 10 bar / Engine oil pres 0 - 16 bar /
Engine oil press 0 - 30 bar : engine oil pressure
Show value as : Engine 1 - 4. Connected engine ID*
Resistive pin 8 Input 8 sensor Input :
l
Off : no connected analog sensor
l
Trim
l
Fresh water : fresh water level
l
Rudder : rudder angle
l
Fuel : fuel level
l
Eng cool temp 40 - 120 °C : coolant temperature
l
Eng oil temp 50 - 150 °C : engine oil temperature
l
Engine oil pres 0 - 5 bar / Engine oil pres 0 - 10 bar :
engine oil pressure
l
Boost pressure 0 - 2 bar : boost pressure
Show value as :
l
Fuel : Tank 1 - 4. Connected tank ID
l
for engine sensors: Engine 1 - 4. Connected engine ID*
Calibration :
l
for Fuel : one or three point calibration (see "Configure and
calibrate the fuel level sensor" on page 68)
l
for Trim , Fresh water and Rudder : three point calibration
(see "Configure and calibrate the other sensors" on
page 69)
Resistive pin 9 Input 9 sensor
Resistive pin 11 Input 11 sensor
Resistive pin 12 Input 12 sensor
Voltage pin 10 Input 10 sensor Input :
l
Off : no connected analog sensor
l
Ext illum : brightness control (day-night) from external
control
l
Engine oil pres 0 - 10 bar / Engine oil pres 0 - 16 bar /
Engine oil press 0 - 30 bar : engine oil pressure
Show value as : Engine 1 - 4. Connected engine ID*
Note *: the displayed ID is increased by 1 from the NMEA ID (i.e. Engine 1=NMEA 0 ID, Engine 2= NMEA 1
ID, etc.).
71
Sensor configuration
7” TFT display | Operating instruction v. 1.0 | © 2018 Continental Automotive Switzerland AG