6 - INSTALLATION
A
D
C
B
Photo 16
6.2
BATTERY INSTALLATION*
The battery compartment is placed underneath
the recovery tank (Photo 14) and to access it, it is
necessary to remove the recovery tank. To
remove the recovery tank, detach the suction
hose from its housing (Photo 4 - B) and lift the
tank by pulling it up as shown in Photo 13.
Place the battery in the battery compartment
(Photo 14) checking that it is in perfect condition.
6.2.1
BATTERY CONNECTION*
(
◊
) Attach the battery wiring to the battery,
connecting the terminals only on the poles
marked with the same symbol (red wiring
“+”, black wiring “-“) as shown in the
connection diagram in Photo 15.
(
◊
)Take care to avoid short circuits over the
battery terminals
After checking that all the controls on the panel are
in position “0” or at rest, connect the battery
connector to the machine connector (Photo 16 -
B). Photo 16 shows the correct battery
connection.
(
!
) Close the battery compartment, replacing
the recovery tank, making sure not to crush any
wire.
6.3
BATTERY CHARGER CONFIGURATION*
(
!
)
The machine is equipped with a battery
charger
configured
for
ENERSYS
maintenance free battery.
We recommend that you use an ENERSYS battery
as replacement. Use of any other battery may
affect the warranty of the product.
Photo 13
Photo 15
A)
12V Battery with cabling
B)
Battery connector
C)
Suction motor thermal breaker
D)
Traction motor thermal breaker
13
* Only applies to VCSD-02 model
Photo 14