25
25
9 - TROUBLESHOOTING
9.1
THE MACHINE DOESN’T WORK
L
The key isn’t inserted or correctly turned.
J
Insert and turn the key to position ON.
L
The battery connector is disconnected or
poorly attached to the main wiring connector.
J
Firmly connect the two connectors.
L
The machine is charging.
J
Complete the charging operation.
L
The batteries are discharged.
J
Charge the batteries.
9.2
THE BRUSH DON’T ROTATE
L
The brush motor switch is not selected.
J
Press the button to activate the brushes.
L
The brush motor thermal breaker tripped;
the motor overheated.
J
Troubleshoot the cause (cords or similar
items that impede movement, surface too
rough, etc.) and press the reset breaker (the
first from the top).
L
The transmission belt is broken.
J
Replace it.
L
The motor relay or brush motor is broken.
J
Replace it.
9.3
NOT ENOUGH OR TOO MUCH CLEANING
SOLUTION
L
The solution water tank is empty.
J
Fill the solution water tank after having
emptied the recovery tank.
L
The solenoid valve switch at OFF position
J
Set the solenoid valve switch to the ON
position
L
The solution water valve is closed or
almost closed.
J
Adjust/increase the detergent solution
outlet flow by turning the adjustment lever.
L
The solution water filter is dirt and clogged
in some point.
J
Open the filter and clean it removing the dirt.
9.4
NO SUCTION
L
The suction hose is not connected to the
squeegee.
J
Connect it correctly.
L
The suction hose or the squeegee conduit
are obstructed.
J
Clean out and remove any obstructions
from the conduits.
L
The suction motor is turned off.
J
Activate it.
L
The recovery tank is full.
J
Empty it.
L
The suction motor is not receiving electric
power or is burned.
J
Check the connections and, for the latter case,
replace the motor.
9.5 INSUFFICIENT SUCTION
L
The cover of the suction compartment is
not perfectly closed.
J
Close it correctly.
L
The suction hose or the squeegee conduit
are obstructed.
J
Clean out and remove any obstructions
from the conduits.
9.6 THE BRUSH MOTOR OR THE SUCTION
MOTOR DOESN’T STOP
J
Stop the machine, cutting off the main power
supply and disconnecting the main battery
connector, and contact the technical service
centre.
9.7 THE SQUEEGEE DOESN’T CLEAN OR DRY
EFFICIENTLY
L
The squeegee blades are worn or are
dragging solid dirt.
J
Replace or clean them.
L
The squeegee adjustment is not correct;
the advancement must be exactly
perpendicular to the running direction.
J
Adjust the squeegee.
L
The suction hose or the squeegee conduit
are obstructed.
J
Clean out and remove any obstructions
from the conduits.
9.8 THE BATTERY CHARGER DOESN’T WORK
L
The battery charge doesn’t start .
J
Check that the battery charger is
connected to the battery. Consult the battery
charger manual.
9.9 THE BATTERIES DO NOT CHARGE OR DO
NOT HOLD A CHARGE
L
The batteries are new and do not
generate 100% of the rated performances.
J
The accumulator reaches the maximum
performance after 20-30 complete charge
cycles.
L
The electrolyte has evaporated and does
not completely cover the plates.
J
Check the battery manufacturer’s use and
maintenance manual.
L
There are significant differences in density
among the various elements.
J
Replace the damaged battery.
Always consult the battery and battery charger use
and maintenance manual. If this does not solve the
problem, contact the authorised technical service
centre.
The manufacturer CANNOT solve problems
caused by using batteries and battery
chargers that were not directly supplied.
Warning- Before undertaking maintenance operations or adjustments switch off the machine
and unplug from the electricity supply or safely disconnect the battery connector.