7
–
OPERATING INSTRUCTIONS
16
7.3
BRUSH ASSEMBLY / DISASSEMBLY
(
!
) Never use the machine if the brush or the pad
holder with abrasive pad is not perfectly installed.
Automatic Brush Assembly:
- Place the brush on the floor; lift the squeegee
using the lifting/lowering lever (Photo 2 - B)
- Holding the handlebar (Photo 1 - A) push it
downward in order to lift the front part of the
machine by rotating it on the rear wheels; move
the machine and place it over the brush, taking
care that the coupling flange on the brush is
under the metal coupling of the machine (Photo
20A and 20B).
(!) Note-It is very important to achieve
correct position of the machine first (Photo
21A) before continuing otherwise brush will
not
couple
automatically.
Incorrect
positioning (Photo 21B) can cause coupling
not to occur correctly
- Switch on the machine using the key switch
(Photo 8 - A) or the general ON/OFF switch on the
control panel (Photo 5 - A).
- Select the brush rotation with the brush switch
(Photo 5 - D; Photo 7 - C) and start the brush
rotation pulling the control lever (Photo 2 - A): the
brush will couple automatically.
- To assemble the pad holder follow the same
procedure.
(
!
) Do not allow the length of the rows of brushes
to become lower than 1 cm.
(
!
) Do not allow the thickness of the abrasive
disks to become less than 1 cm.
- Working with excessively worn brushes or
excessively thin abrasive disks may damage the
machine and the floor.
- Regularly check the wear on these parts
before starting to work.
Manual Brush Assembly
-
Disconnect machine from mains or attach
battery cut-off key. Recline the machine and
attach brush to coupling system.
Disassembly or replacement:
- Lift the squeegee using the lifting/lowering lever
(Photo 2 - B)
- Holding the handlebar (Photo 1 - A) push it
downward in order to lift the front part of the
machine by rotating it on the rear wheels;
- Select the brush rotation with the brush switch
(Photo 5 - D; Photo 7 - C) and start the brush
rotation pulling the control lever (Photo 2 - A) while
holding the machine lifted up; release the control
lever to stop the rotation: the brush will unhook
automatically.
To disassemble the pad holder follow the same
procedure in reverse.
7.4
MACHINE TRANSPORT
To transport the machine while not working,
proceed as follows:
Switch OFF the machine using the key switch
(Photo 8 - A) or general ON/OFF switch on the
control panel (Photo 5 - A).
Lift the squeegee using the lifting/lowering lever
(Photo 2 - B).
Holding the handlebar (Photo 1 - A), push it
downward in order to lift the front part of the
machine by rotating it on the rear wheels;
While holding the machine in this position, push
it to the new working area or to the storage area.
Photo 20A
Photo 20B
Photo 21A
Photo 21B