Page 10
ECS 2M
2.2 MOUNTING
Use a screwdriver to remove the faceplate and the plate
on the power compartment.
Once both faceplates are off, install the mounting screw on the
wall and install the unit on it. Use two more screws to secure
the ECS-2 M in place using the bottom mounting holes.
2.3 SWITCH SETTINGS
The ECS-2M is configured for a variety of options via two
switches as follows:
2.3.1 - Line Voltage Selector Switch
This switch is located on the surface of the main (bottom)
board and adapts the control panel for 115 VAC or 230
VAC line voltage.
Refer to Figures 1, 2, and 3.
To limit the unit’s exposure to noxious gases install it in
a hallway.
Make sure the unit is mounted right side up, with the
cable entry holes facing down.
The ECS-2M will operate in a temperature range of 32°F -
120 °F (0 °C - 50 °C).
* It is prohibited to use overhead cables outside the building.
Mounting hardware is not included with the unit.
230V
115V
www.monitrol.com
Summary of Contents for ECS-2M
