PJGCV160 / PJGCV190 / PJXP200
PROBLEM
CAUSE
SOLUTION
Gearbox or adapter output
shaft is not turning
not engaged gear or clutch of
the driving unit
- engage gear or the clutch
engine centrifugal clutch is
slipping
- degrease the gearbox clutch plate and check the sealing of the gearbox
and the engine crankshaft
- check the clutch lining integrity
- service visit
faulty clutch plate mounting
- service visit: parts replacement
jiná závada
- service visit
Oil leaks around the
engine output shaft
damaged packing
- service visit: parts replacement
Oil rises into the clutch
plate space
damaged sealing under the
clutch plate
- service visit: parts replacement
Other defect
- service visit
Table 25: Problems and their solutions
2.7.3 Storage
Before longer-term storage (e.g. after the season) clean the machine of all dirt and plant residues. Prevent unauthorized persons access
to the machine. Protect the machine against the climatic conditions but do not use airtight protection to prevent higher corrosion of the
machine.
We recommend that after the season you have the machine prepared for the next season in one of our authorized service centres. Note
that before the season our service network is fully booked up.
We especially recommend:
to conserve worn out places on working implements.
remove all dirt and plant residues from the machine.
repair damaged places on painted parts.
lubricate the machine in accordance with recommendations given in
2.7.3.1 Machine washing and cleaning
When cleaning and washing the machine proceed so as to observe valid regulations and laws on the protection of waterways and other
water resources from pollution or contamination by chemicals.
Do not use pressure washer to wash the machine with the mounted driving unit. Apply only hand wash using a
brush or rag.
2.7.4 Disposal of packaging and the machine at the end of lifetime
After unpacking the machine the user is required to dispose of packaging in accordance with national laws and
regulations on waste management.
We recommend to dispose of the machine at the end of its lifetime in the following way:
1.
Dismount all machine parts that can be still used.
2.
Drain the oil from the driving unit into a suitable sealed container and take it to waste disposal collection point
3.
Dismount plastic and non-ferrous metals parts.
4.
Dispose of the machine remainder and dismounted parts according to national laws and regulations on waste management.
2.7.5 Instructions for ordering spare parts
These Instructions for use do not include a list of spare parts.
For proper identification of your machine, you must know the Type designation (Type), Serial Identification Number (№) and Purchase order
number (C№). They are given on the machine nameplate, on the box or in the Guarantee certificate. Only with this information it is possible to
accurately trace the spare part designation at your dealer or authorized service centre. You can find the list of authorized service centres on our
website
To find spare parts in the electronic catalog of spare parts at the website address
it will suffice if you enter the first 10
characters of the Identification number №. If you do not have Internet access, you can request a catalog in printed form on the COD basis.
43
The relevant local authority will advise you of the waste disposal collection point address.
26
R
ev
iz
e
0
4
/2
0
1
5
Summary of Contents for GLOBAL PJGCV160
Page 2: ......
Page 14: ...PJGCV160 PJGCV190 PJXP200 14 Revize 04 2015...
Page 44: ......
Page 45: ......
