VANLEIGH PINECREST, Owner'S Manual

Page: 104 / 158

P I N E C R E S T O W N E R ’ S M A N U A L
NEVER use a solution containing ammonia or chlorine when locating leaks. These products are corrosive to copper
gas lines and brass fittings, which could result in deterioration of the copper and brass components.
If a leak is not fixed by tightening the connection, shut OFF the propane system valve(s) and immediately contact
your dealer or a qualified propane service representative.
P R O PA N E A L A R M
Your RV is equipped with a propane alarm. Please read and follow the component manufacturer instructions sup-
plied in your Owner Information Package.
For detailed information on this alarm, See Pages 34 & 35, Occupant Safety
I N S TA L L I N G T H E P R O PA N E C Y L I N D E R S
The position of the propane cylinder(s) and hoses is critical to proper operation and propane flow. Follow these
instructions to make sure your propane container(s) are connected properly.
1. Make sure all the RV appliances are shut off.
2. Make sure each LP cylinder shut-off valve is closed.
3. Connect the 3/8˝ low-pressure hose to the outlet of the two-stage regulator.
4. Place the cylinder on the bracket in the recess compartment or housing and secure it so the outlets of the cylin-
der valve are facing the “sidewall” of the compartment or housing.
5. Mount the regulator on the center back wall of the compartment or housing so the vent is pointed downward.
6. Attach the 1/4˝ inverted flare x 18˝ Type-1 pigtail hose to the regulator inlet and the right-hand swivel nut to the
cylinder valve.
7. Attach the main supply hose from the regulator to the brass manifold fitting in the frame of the trailer. The swiv-
el brass nut on the main hose will be your final attachment.
Remember each time the propane container is removed:
• Check that ALL fittings are tight.
• Check that ALL connections are tested with a propane leak detector (or soapy water) solution.
• Open the main shut-off valve on the LP cylinder slowly . This avoids propane freeze up, caused by a fast rush of
propane to the excess flow valve.
• If you do experience a propane freeze up, close the main valve and wait at least fifteen (15) minutes before try-
ing again. For more information, refer to the regulator manufacturer’s operator manual.
• Listen carefully. A hissing sound longer than one second, may indicate a propane leak. If you suspect that there
P R O PA N E S Y S T E M