EZCT S2 USER’S MANUAL
REV 3
30
3.4
Working With Test Plans
A test plan is comprised of the saturation test voltage, current range selection, CT nameplate
ratios, and CT winding terminal combinations (X1 to X5) for each test. Up to 10 test definitions
can be stored per test plan, and up to 128 CT test plans can be stored in the EZCT S2’s Flash
EEPROM. The ability to use test plans makes CT testing an extremely simple process. To
perform a test, the EZCT S2 is connected to the CT terminals and a test plan is selected to run.
3.4.1. Extracting the Test Plan From a Test Record
A test plan can be extracted from a test record for immediate or future use. You can extract the
test plan immediately after performing a test or you can extract the test plan from a restored
test record (see section 3.3.1 for instructions on how to restore a test record). To extract a test
plan from a test record:
a.
Either perform a test (see section 3.2) or restore a test record (see section 3.3.1) that
you would like to extract the test plan from.
b.
Start from the “START-UP” menu:
Press the
[3]
key (
TEST PLANS
).
c.
The following screen will be displayed:
Press the
[4]
key (
NEXT PAGE
)
d.
The following screen will be displayed:
Press the
[1]
key (
EXTRACT TEST PLAN
)
NOTE
If there is no test record in the working memory, the following screen will be
displayed:
NO RECORD LOADED!
1.
LOAD TEST PLAN
2.
UNLOAD TEST PLAN
3.
PLAN DIRECTORY
4.
NEXT PAGE
1.
EXTRACT TEST PLAN
2.
PRINT TEST PLAN
3.
ERASE TEST PLAN
1.
RUN TEST 12/05/09
2.
SETUP 08:20:25
3.
TEST PLANS
4.
DIAGNOSTIC
Summary of Contents for EZCT S2
Page 23: ...REV 3 EZCT S2 USER S MANUAL 19 Figure 5 Typical EZCT S2 Tabulated Report Printout...
Page 25: ...REV 3 EZCT S2 USER S MANUAL 21 Figure 6 Typical EZCT S2 Graphic Report Knee Point Marker...
Page 31: ...REV 3 EZCT S2 USER S MANUAL 27 Figure 7 Typical Internal Test Record Directory Printout...
