REV 3
EZCT S2 USER’S MANUAL
25
3.3.2. Printing a Restored Test Record
You can print a test record at the time that it is restored from the Flash EEPROM (see section
3.3.1), or you can restore it to the working memory and print it later. To print the current test
record in the working memory:
a.
Start from the “START-UP” menu:
Press the
[2]
key (
SETUP
).
b.
The following screen will be displayed:
Press the
[2]
key (
PRINT RECORD
).
c.
The following screen will be displayed:
NOTE
If there is no test record in the working memory, the following screen will be
displayed:
Press any key to return to the “START-UP” menu. Please see section 3.3.1 for
instructions on how to restore a test record.
Press the
[1]
key to print the tabulated data and graphics results on the thermal printer.
The test record will be printed on the thermal printer and you will be returned to the
“START-UP” menu.
Press the
[2]
key to print the test report and graphic results on the thermal printer,
without the excitation voltage and current data points. The test record will be printed
on the thermal printer and you will be returned to the “START-UP” menu.
NO SHOTS TO PRINT!
PRINT OPTIONS:
1.
FULL DATA
2.
ABBREVIATED DATA
1.
RECORD ID
2.
PRINT RECORD
3.
RESTORE RECORD
4.
NEXT PAGE
1.
RUN TEST 09/24/09
2.
SETUP 08:20:19
3.
TEST PLANS
4.
DIAGNOSTIC
Summary of Contents for EZCT S2
Page 23: ...REV 3 EZCT S2 USER S MANUAL 19 Figure 5 Typical EZCT S2 Tabulated Report Printout...
Page 25: ...REV 3 EZCT S2 USER S MANUAL 21 Figure 6 Typical EZCT S2 Graphic Report Knee Point Marker...
Page 31: ...REV 3 EZCT S2 USER S MANUAL 27 Figure 7 Typical Internal Test Record Directory Printout...
