13
10.
Press “
ENT
”.
11.
Choose “
ActivateSensor
” and press: “
ENT
”.
12.
When appears: “
Learning
”, Trigger the Motion Detector two times by pressing the small
jumper on the device’s board (if the Motion Detector is open) or just trigger the sensor by
moving your hand in front of the Motion Detector so that the sensor can detect your hand
and trigger the alarm.
13.
It will appear on the screen: “
Success
” in case of “
Failure
” please repeat the process one
more time.
14.
Done!
7.
Outdoor Siren:
How to install:
Activate the built-in rechargeable backup battery from the back side and proceed to fix
it to the wall with the screws. We recommend you to set it outside of your home.
In order to link the Outdoor Siren to the system it is needed to turn the Siren in learning mode then
trigger the Alarm System and disarm.
Note:
-
Please check the backside of the Siren and find the green and red button, the green button is used
to turn on or off and the red button is used to turn the device in learning mode.
- There are two ways to link the Siren to the system: using the remote control or directly from the
alarm host.
Please follow the next steps to link the Outdoor Siren
using a Remote Control
:
1.
Press: the green button on the backside of the Siren to turn it on.
2.
Press: the red button on the backside of the Siren to turn the device in learning mode (all
LED lights will turn to indicate that learning mode is activated).
3.
Activate the Alarm System from the Remote Control by pressing emergency button “ ”
then disarm the system from the remote control.
